Remote Control

There are several ways that you can control Numerology from MIDI sources as well as the computer keyboard. This chapter describes both approaches.

MIDI Assign : Controlling Modules Parameters via MIDI CC

Most module parameters can be controlled from any source of MIDI CC messages that is connected to the computer. Typically this is some type of MIDI controller with buttons, sliders and knobs that is connected to the computer via USB or MIDI, but it can be any source of CC messages.

To remove an assignment for a parameter, right-click on it and choose "Un-learn MIDI CC".

Triggering Stack Presets via MIDI

Presets for a stack can be triggered by MIDI Note or Program Change messages. To set this up, you first need to select the MIDI source you want to use in the "MIDI Remote" menu on the back-panel side of the Stack Input module. Then double click on the preset to bring up the PresetDetail dialog. In the MIDI Assign section, choose "Note" or "Prog Change" for the type, enter the note number or program change number, and choose the MIDI Channel. Keep in mind that preset changes are quantized in time by default, so they may not be triggered exactly when you press the note. To change that behavior, use the Quantize menu on the Mixer channel for each stack.

Triggering Stack Presets via the Computer Keyboard

You can also setup triggering of a preset from the computer keyboard. Double-click on the preset to bring up the Preset Detail dialog, then enter any letter, a-z or A-Z and click "Save".