jim
04-26-2009, 11:43 PM
mo fixes.... thanks again to everyone who sent in those bug reports... :)
http://www.five12.com/Numerology-2.1rc3.dmg
Numerology 2.1rc3 Release Notes:
Note Sequencer Play Mode Updates:
- Fixed a bug where sequencers using MIDI trigger modes would not stop properly.
- Added a preference where triggering can be quantized to the next beat. This value is on by default for new projects.
Misc Fixes / Updates:
- The PolyNote now correctly transposes when "MIDI Transpose" is on. The center note for transpositions is always note number 60 (a.k.a C3)
- "Zero All" now works correctly for the ChordSeq.
- Fixed a stuck note bug.
- Fixed a bug whereby the selected factory preset wasn't readable in the preset selection dialog.
- Fixed a bug where MIDI transpose was not working for the PolyNote
- Fixed a param mod bug where the ModulationSeq, LFO and Envelope modules could not reliably modulate params in other stacks -- when the project was loaded from a file, the modulation wouldn't setup properly.
- Tweaked a parameter name for the LFO & Dual LFO modules ("Frequency" -> "Frequency / Period")
- Changed the default transport loop to be 1 -> 17, which will loop the first 16 bars.
- Doc updated for all new features in 2.1.
http://www.five12.com/Numerology-2.1rc3.dmg
Numerology 2.1rc3 Release Notes:
Note Sequencer Play Mode Updates:
- Fixed a bug where sequencers using MIDI trigger modes would not stop properly.
- Added a preference where triggering can be quantized to the next beat. This value is on by default for new projects.
Misc Fixes / Updates:
- The PolyNote now correctly transposes when "MIDI Transpose" is on. The center note for transpositions is always note number 60 (a.k.a C3)
- "Zero All" now works correctly for the ChordSeq.
- Fixed a stuck note bug.
- Fixed a bug whereby the selected factory preset wasn't readable in the preset selection dialog.
- Fixed a bug where MIDI transpose was not working for the PolyNote
- Fixed a param mod bug where the ModulationSeq, LFO and Envelope modules could not reliably modulate params in other stacks -- when the project was loaded from a file, the modulation wouldn't setup properly.
- Tweaked a parameter name for the LFO & Dual LFO modules ("Frequency" -> "Frequency / Period")
- Changed the default transport loop to be 1 -> 17, which will loop the first 16 bars.
- Doc updated for all new features in 2.1.